I took me about 45 minutes after coming home from the hardware store to drill/screw it together then I was up and running! I have pics of the back side of the plywood at the Elektronauts forum (Digitakt setup page) or I can help you out if you’re interested in doing similar. It just squeezes in and out between the felt pieces. Spaces the two side brackets, with felt circles, so that it presses and holds the Force in tight even at steep angle, but easily removable.
Used black duct tape around edges so I wouldn’t have to paint it. So only tools I needed was a drill, drill bit, screw driver, small wrench. Put the VESA plate centered on the plywood, traced and drilled the 4 holes, bought 4x screws/washers/bolts. Then 4 ‘L’ brackets that I screwed in by hand (2 at bottoms, 1 each side near top), 4 felt pieces (for chair bottoms) so it doesn’t scratch the Force. (The Force is 14wx15L, I had my cut 14x17l so I could have a little lip at the back)
I went to HomeDepot, bought a 2’x4’ piece of 1/4” plywood and had them cut it to size for me.
Info on how he built the board the Force is on.
0 kommentar(er)
